Installation
9
Tips for installation
•
Check the delivery scope components before beginning installation;
this way you save time and unnecessary effort if a part is missing.
•
It is safest and quickest to do installation with two people.
•
If the operator cannot be installed in the centre of the door, it may be
shifted. Make sure that the door does not bow and get stuck in the rails.
Check:
Open and close the door by hand several times at the location where
the operator is to be installed. If the door can be operated easily at this
location (without exceeding the speci
fi
ed forces), then the operator can
be installed.
•
Swing doors:
Because the mechanical locking of a door equipped with a operator
must be removed or disabled, depending on the design of the door,
it could be possible to manually raise the door approx. 50 mm.
To counteract this, spring catches can installed to lock the door
in addition to the operator.
These spring catches are connected to the operator by means
of a locking set; when opening a door, the spring catches must
fi
rst be disengaged before the operator can open the door.
Important information!
Additional pulse transmitters are: Handheld transmitters,
Telecody, wireless indoor switches and key switches.
In the case of the handheld transmitter, Telecody
or the wireless indoor switches, a connecting line
to the operator is not required; consult your dealer.
Selection of installation variants
Caution!
The chain cover is not packaging.
Do not remove it!
Important information!
Select the variant you wish to install. Convert the power feed
for variant (A).
Installation variant A
Installation variant B
V
V
7
A
B
