XT Heated Humidifier/ English
6
3. Installation
3.1 Set Up
1. Place the CPAP device onto the humidifier platform so that
the four rubber knobs on the bottom of the CPAP device
align with the four matching indentations on the platform.
Also make sure that the Locking Tab fits squarely into the
slot in the rear of the CPAP unit (beneath the power socket).
This will keep the CPAP device in place on top of the
humidifier.
2. Place the CPAP with humidifier onto a flat surface. This
surface should be lower than the level at which you will be
sleeping.
3.
Connect the power jumper cord to the AC inlet on the back
of the CPAP device.
4. Connect the AC power cord to the power socket (inlet) on
the back of the humidifier, and plug it into a main outlet.
NOTE:
1. Make sure the heated humidifier unit
is suitable for the local power voltage.
2. The plug also can serve to disconnect
the device. Do not position the
equipment so that it is difficult to
operate the disconnecting device.
