17
EZ6037M Metal Sander
Adjusting Contact Drum for Abrasive Belt Thickness
If using sanding belts that vary a lot in thickness
(Example : 220 cloth back to a scotchbrite belt)
Follow the procedure below to
“raise or lower” contact
drum depending on abrasive belt or scotchbrite belt.
So you maintain the same hold down roller pressure.
1. First determine the difference in thickness from
the belt you were using to the one you will put on
the machine. Use a calipers to measure the
difference or check with your belt supplier.
2. Loosen locking lever (A figure 10.1)
3. Rotate drum adjustment lever (B figure 10.1)
to raise or lower the contact drum using the
dial indicator to check the amount of movement
of the drum per the distance you determined
in step 1.
4. Tighten locking lever (A figure 10.1)
5. Now follow the instructions on page 14 for
Sanding Belt Oscillation Adjustment
and
adjust the new belt so it oscillates properly.
Caution:
Abrasive belt or Scotchbrite belt must be a minimum
.040 / 1 mm higher than the hold down rollers for
proper feeding pressure. Failure to do so could cause
possible improper feeding of the product and/or
possible kick out
.
Figure 10.1
A
B
Summary of Contents for EZ Sander EZ3760M
