FITTING THE DECORATIVE FRAME
The appliance is supplied with a decorative frame, the frame attaches to the firebox as a three piece or one
piece clip-on unit.
Place the magnets supplied to the outer frame of the fire box.
A plastic protective coating may be applied to the face of the frame assembly, which should be removed at
this stage; the one piece unit can be placed in position.
With the three piece unit you should start with the side pieces of the clip-on assembly, these should be
pushed into position first, followed by the top bar, which should overlap the sides.
IMPORTANT NOTE: Due to the possibility of sharp edges, care should be taken when handling the three
piece frame components, the use of protective gloves is recommended.
Place the fire front/ fret into position in front of the fire and slide the ashpan door into place.
The fire front/fret shown in these instructions may differ from the one supplied with the appliance, we
strongly recommend you use a fire front/fret supplied by Apex fires as these products will have been tested
with the appliance, although other fire front/frets will be compatible.
