OPERATION
This appliance can be operated by both remote control and manual button. Once the
unit has been properly connected to an earthed electrical outlet, turn on the main
switch. A beep should be heard when the power is first applied.
NOTE: To use both remote and manual functions the main on/off switch must be
in the ‘on’ position.
●
Operating by Manual Button
FL AME H EATER
Main power switch
Flame button
Heater button
FLAME HEATER
NOTE
：
The flame will always operate when the appliance is switched at the main power
switch.
Main power switch
The POWER switch supplies power to all of the functions of the fireplace. This switch must be in the
“ON” position for any of the functions including the remote to work.
Flame button
The fire has four flame effect settings. Pressing the flame effect button will cycle the fire
through each effect
.
Heater button
Press once and the heater fan will turn on, and 8secs later the element will switch on to the low
setting. (Pilot lights illuminated
●○
)
Press again turns on High heat. (Pilot lights illuminated
●●
)
Press again and it will turn the heat off. 8secs later the heater fan will turn off. (Pilot lights
illuminated on fire screen
○○
)
There are 3 levels you can cycle through including the OFF setting.
●
Operating by Remote Handset
z
Make sure the batteries are installed properly in the remote control.
、
z
The effective range of the remote control is up to 4 metres or 13 feet.
Multifunction Infrared Remote Handset
