ICON
TITLE
FUNCTION
POWER
Press once will turn the fire on. Press again turns the fire off.
FLAME
The fire has four flame effect settings. Pressing the flame effect
button will cycle the fire through each effect.
HEATER
Pressing once will turn the heater fan on. 8secs later the element
will switch on to the low heat setting. (Pilot lights illuminated on
fire screen
●○
)
Press again turns on High heat. (Pilot lights illuminated on fire
screen
●●
)
Press again and it will turns the heat off. 8secs later the heater fan will turn
off. (Pilot lights illuminated on fire screen
○○
)
There are 3 levels you can cycle through including the OFF setting.
TEMP
Digital display shows the TEMP setting 23°C (default), with 14
settings from
“OFF”, “16°C” to ”28°C”.
The TEMP will increase by 1°C up to 28°C when pressed each
time.
By pressing the TEMP for 3S, the digital display can show
between °C and °F.
TIMER
Once the fire has been switched on. The timer can be set to
switch off the fire for the following delay periods. 0.5H, 1H, 2H,
3H, 4H, 5H, 6H, 7H, 8H, to 9H.
MAINTENANCE
Warning: Before any maintenance and/or cleaning the exterior of the fireplace, disconnect
the unit from the power supply and leave until cooled off.
Remote Handset Battery Replacement
Replace with two AAA batteries.
Make sure the batteries are installed correctly in the remote
control.
Maintenance of Motors
The motors used on the fan and flame effect are pre-lubricated for extended bearing
life and require no further lubrication.
Periodic cleaning/vacuuming of the fan/heater
inlet and outlet is recommended.
Reset the overheat protection device
Your heater includes a protection device that shuts off the heater if it overheats for any
reason:
To reset the heater
1) Turn off the unit.
2) Unplug unit and wait for 5 minutes.
3) Plug back in and turn on.
Ensure that the appliance is functioning correctly. If the control operates again, check
that the heater/fan inlet and outlet grilles are not blocked with hair/lint. Clean/vacuum. If
the control operates again the appliance must be checked by a competent Electrician
