17
•
Before working with batteries turn the key switch to the OFF position.
•
Avoid short circuiting the battery terminals through accidental contact with metallic
objects, like tools, across the terminals.
Battery Handling Safety
When removing or installing, check which is the negative and positive terminal.
Removing Batteries:
1. Disconnect the (-) terminal connected to the ground wire.
2. Disconnect the (+) terminal connected to the starter
When installing the batteries, follow this procedure in reverse order.
3. Tighten the battery terminals securely; check that the terminals are not lose by
trying to move the cables by hand. Loosened cables can generate sparks and lead
to an explosion.
FIRE PREVENTION
•
Remove all fiber mulch, leaves, paper and other flammable material accumulated in
the engine compartment or other places on the Applicator. This could cause a fire.
•
Marshland, when dry, is highly flammable. Marshland can self-ignite even in low
temperatures. Always keep the engine compartment and engine clean.
•
Check fuel, lubrication and hydraulic system for leaks. Have any leaks repaired
immediately. Clean up any excess oil, fuel or other flammable fluids and dispose of
properly.
•
Be sure the fire extinguisher is present and working. The fire extinguisher is located in
the cab, on the left hand side of the operators seat.
SHORT TERM STORAGE
1. Drain the slurry tank of all water and material prior to storage and leave the drain
plug uninstalled.
Hydroseed material can produce gases that are
harmful or deadly if inhaled. Empty the slurry tank
daily to prevent build-up of these gases.
Do not store material for long periods of time in
the slurry tank. Harmful or deadly gases could
result.
Summary of Contents for XA1200
Page 11: ...11...
