35
plate.
e. Rotate the tab outward to clear the work area above the guard rail.
4. Select the appropriate nozzle.
5. Confirm the gasket is correctly in place before connecting.
6. Open the discharge ball valve.
7. Aim discharge boom at the area where product is to be applied.
8. Firmly hold the discharge boom handle.
9. Press the PUMP CTRL ON button to engage the slurry pump. Press the PUMP
˄
button and material will begin to flow through the discharge boom. Use the UP and
DOWN arrow buttons to increase or decrease the spray distance.
The XA1200 incorporates a 2-position engine throttle,
idle speed (1350 rpm) and full rpm (2500 rpm). The
engine throttle automatically increases to full rpm
whenever the slurry pump is engaged. The engine will
return to idle speed when the slurry pump is
disengaged.
10. Apply product evenly along the area.
Note: It may be necessary to apply the product in multiple directions to
completely cover the ground.
Do not exceed 5 mph operating speed.
Excessive
speed could cause severe injury or death.
Take note of uneven ground or obstacles that the
operator may not notice and communicate them
immediately. Operating on unstable surfaces could
cause severe injury or death.
Application from Hose Reel (Optional)
1. Observe the application area and make note of any obstructions that might be
encountered.
2. Unroll the hose to the farthest point from the Applicator. Work back towards the
Applicator to limit the foot traffic on the areas with product already applied.
3. Select the appropriate nozzle.
4. Open the recirculation ball valve.
Summary of Contents for XA1200
Page 11: ...11...
