40
Be careful not to crank the engine for more than 30
seconds without at least a 2 minute cool down period.
This will prevent damage.
Do not prefill the filter element with fuel before
installing. This could introduce dirt into the fuel
system and damage engine components. Utilize the
priming pump on the engine to fill the filter with fuel.
Engine Air Filter
The XA1200 is equipped with a dual stage engine air filter. Apex recommends replacing
the inner filter every time the outer filter is changed.
Do not use compressed air to clean the filter between servicing. Cleaning the air filter
can introduce dirt into the engine, causing severe damage.
Lubricating Grease
The XA1200 is completely serviced before leaving Apex. The operator should be familiar
with all grease points as well as the proper grease type for each application. Apex uses
NLGI #2 EP rated grease that provides the proper protection in a wide range of
temperatures.
There is one grease point on the XA1200 at the front of the unit, for the agitator bearing,
two grease points on the slurry pump drive shaft, two grease points on the discharge
boom swivel and two on the hose reel, if equipped.
Summary of Contents for XA1200
Page 11: ...11...
