23
※
When the upper part of the center switch is pressed, the
operation is the same as when the rotary switch is turned
clockwise. When the lower part of the center switch is pressed,
the operation is the same as when the rotary switch is turned
Counterclockwise.
＝
■
When selecting [1 Channel]
(1)
Select a display item
Operate the upper part or lower part of the
switch in the display item selection mode
to select a display item. The selected item
is displayed as a reversing display.
(2)
Make a display
Press the right part of the switch or press
the center pushbutton to make a display.
■
When selecting [2 to 4 Channel]
(1)
Select a display channel
Operate the upper part or lower part of
the switch in the display channel selec-
tion mode to select a display channel.
The number of the selected channel is
displayed as a reserving display.
(2)
Select a display item
Select a display channel and operate the
right part of the switch to set the display
item selection mode. The numeric value
of channel and the display item are
displayed as a reversing display. In this
status, operate the upper part or lower
part of the switch to select a display item.
(3)
Select a display item of another
channel
Operate the left part of the switch in the
display item selection mode to go back to
the display channel selection mode.
Repeat steps (1) and (2) until all the
display items are set.
(4)
Make a display
Operate the right part of the switch in the
display item selection mode, or press the
center pushbutton in the display channel
selection mode and select [Nx] in the
popup menu to make a display.
The above display screen example is
displayed when the sensor type is a hot wire
type or a flap type and [2 Channel] is selected.
３
.
Select the data to be display in the item
selection menu
or
Nx
or
Pr
Display channel selection
or
Ｎｘ
Display item selection
Go back
Select
Enter
Display item selection
Select
Select
Enter
