37
1. Ne01 / Ne02 RPM check
Turn on the ignition switch, and check the Ne01/Ne02 RPM at air correction point
setting [Ne-Point]. The initial value is 1000 rpm for Ne01 and 1600 rpm for Ne02.
2. Thr / Afl / Rev check
In the monitor mode [Monitor], make a selection so that the throttle opening (Thr),
engine RPM (Rev), and airflow usage ratio (Afl) may be displayed.
Start the engine and set the gear to the neutral position. Before the engine is warmed
up, perform the following operations.
1. Hold the engine RPM of Ne02 (initial value: 1600 rpm). At that time, check the
throttle opening and the airflow usage ratio.
2. Hold the engine RPM of Ne01 (initial value: 1000 rpm). At that time, check the
airflow usage ratio.
3. Input Dec-Air
Select Thr of the deceleration air upper
limit setting [Dec.-Air] and input a
smaller numeric value than the throttle
opening checked in 2-1). Next, select
Ne01 and input a larger numeric value
than the airflow using ratio checked in 2-2).
Lastly, select Ne02 and input a larger
numeric value than the airflow using
ratio checked in 2-1).
(1)
Select a throttle opening and an engine RPM
Press the upper or lower part of the center switch or turn the rotary switch counter-
clockwise or clockwise to select an engine RPM point. The selected item is displayed
as a reversing display. When the rotary switch is turned clockwise, the cursor is
moved upward. When this switch is turned counterclockwise, the cursor is moved
downward.
(2)
Set a numeric value
Select each item and press the right part of the center switch. The throttle opening can
be set by Thr and the upper limit of airflow usage ratio can be set by Ne01 and Ne02.
When the upper or lower part of the center switch is pressed, or the rotary switch is
turned counterclockwise or clockwise, the numeric value is increased or decreased.
When the rotary switch is turned clockwise, the numeric value is increased.
When this switch is turned counterclockwise, the numeric value is decreased.
(3)
End the setting
Select [Pr] in the popup menu after pressing the center pushbutton or press the left
part of the center switch at item selection (Thr, No.01 and No.02), and the setting
menu will reappear.
Setting Dec.-Air
