45
Select
●
When the sensor type is set to Hot-Wire or Pressure
■
Depending on the car specifications, the In setting and the Out setting must be changed even if the car model is the same.
(Example
)
Silvia
S14
SR20DET
‘93.10
〜
‘98.12
※
When the ECU is Normal and the airflow sensor is for Z32
In
02
＝
Z32 airflow sensor
Out 05
＝
S14 normal airflow sensor
※
When the ECU has the
characteristics of an airflow
sensor for Z32 and the airflow sensor is for Z32
In
02
＝
Z32 airflow sensor
Out 02
＝
Z32 airflow sensor
※
When the ECU and the airflow sensor are Normal
In
05
＝
S14 normal airflow sensor
Out 05
＝
S14 normal airflow sensor
４
.
Set the sensor number
Pr
For the sensor numbers, refer to the Wiring diagram by model on the separate sheet.
For ordinary use, set the same sensor number between In and Out.
●
For Pressure, the setting is completed
After the setting of the above (3) is completed, exit from the setting screen.
At this time, the set numeric value is saved.
●
For Hot-Wire, set the sensor output calculation method
Select [Nx] in the popup menu after pressing the center pushbutton or press the right
part of the center switch at Out selection, and the sensor output calculation method
setting screen will appear.
or
Go back
Increase/
decrease
or
(1)
Select In/Out
Operate the left or right part of the center switch to
select In or Out. The selected numeric value is
displayed as a reversing display.
(2)
Set the sensor number
Select a numeric value and press the upper or lower
part of the center switch or turn the rotary switch
counterclockwise or clockwise to increase or
decrease the numeric value.
When the rotary switch is turned clockwise, the
numeric value is increased. When this switch is
turned counterclockwise, the numeric value is
decreased.
(3) End the setting
Select [Pr] in the popup menu after pressing the
center pushbutton or press the left part of the center
switch at In selection, and the sensor type setting
screen will reappear.
