51
Select
●
When No throttle signal (
＊＊
) is set, correction is not performed by
throttle opening, so you can set only the Hi mode [Hi-Thrtl] in the
air correction factor setting mode. The Lo mode [Lo-Thrtl] cannot
be selected. In the monitor mode, the throttle opening cannot be
monitored.
NOTE
※
Set the throttle sensor type after checking the voltage in the
completely closed/opened status of the throttle in the sensor
voltage check mode described on the next page.
(3)
Select the throttle sensor type
Press the upper or lower part of the center switch or turn the
rotary switch counterclockwise or clockwise to select the
throttle sensor type (Thr). The selected item is displayed as a
reversing display.
(4)
Set the throttle sensor type
Select an item and press the upper or lower part of the center
switch or turn the rotary switch counterclockwise or clockwise
to change the direction of the arrow (sensor type). When the
rotary switch is turned clockwise, the operation is the same
as when the upper part of the center switch is pressed.
When the rotary switch is turned counterclockwise, the
operation is the same as when the lower part of the center
switch is pressed.
(5) End the setting
Select [Pr] in the popup menu after pressing the center
pushbutton or press the left part of the center switch at
number-of-cylinders (Cyl) selection, and the etc. menu will
reappear.
※
Pressing the upper part of the center switch provides the
same function as turning the rotary switch clockwise, and
pressing the lower part of the center switch provides the
same function as turning the rotary counterclockwise.
When the throttle is completely closed, the throttle sensor voltage is 0 V to 1 V.
When the throttle is completely opened, the throttle sensor voltage is 3 V to 5 V.
When the throttle is completely closed, the throttle sensor voltage is 3 V to 5 V.
When the throttle is completely opened, the throttle sensor voltage is 0 V to 1 V.
No throttle signal
