A
MENU BUTTONS
A.2
Rear panel
A.1.9
Limiter Indicators
The limiter indicators are a collection of indicators which signal different information about
the limiter status. The
<
SIG
>
indicator shows signal presence and will illuminate when a
signal above - is present in the output. The second indicator
<
-6dB
>
shows that the signal
has reached 6dB below the limiter threshold. The third
<
LIM
>
indicator signals that the
threshold of that output channel has been reached. The
<
X
>
indicator also refers to the
excursion limiter and will illuminate when the threshold of the excursion limiter has been
reached. This
<
X
>
also indicates a signal 6dB higher than the limiter threshold. The
<
T
>
indicator shows that the power limiter is active, which will prevent long term thermal damages.
Please note that because of the long release time of the thermal limiter, the
<
T
>
indicator
may remain illuminated for several seconds after signal on that channel is reduced. The
<
T
>
indicator illuminates when the limiter is in at least 1dB of limit.
A.1.10
Selection Indicators
Each page that is visited when navigating will usually show either one, two or three parameters
labelled
A
,
B
and
C
, each of which can be edited by turning the Encoder associated with that
parameter also labelled
A
,
B
and
C
.
A.2
Rear panel
1-
Ethernet
Port
5-
Power
Inlet
3- Audio
Output
Connectors
4- Audio
Input
Connectors
2- Optional Networked
Audio Ports
(ex: Dante)
6-
Aux Port
Figure 3: Rear panel
A.2.1
Ethernet Communications Port
APG DMS48 processor may be controlled entirely from another controller, typically a Personal
Computer, running an application that is compliant with the ObCom standard such as PWAPG.
Connection will normally be made to the controller via this Ethernet port connector. This port
is also used for updating the firmware in the unit.
A.2.2
Networked Audio Ports
The DMS48 has the option for networked audio ports; if none are required a blanking plate
will be fitted. There are several options for networked audio including Dante and AVB. For a
full list please consult your vendor.
User Manual DMS48
V1.1
13
Summary of Contents for DMS48
