APC-3x93P User Manual
56
Chapter 5 Touch Screen Installation
This chapter describes how to install drivers and other software that will allow your Touch Screen
Controller Board to work with different operating systems.
5.1 Introduction to Touch Screen Controller Board
15
” projected capacitive touch panel control board is a touch screen control board designed for USB
interface and specific for touch screens. It is designed with USB interface features with multiple
devices supporting function. It is designed for Projected Capacitive Touch Panel (PCAP) application;
through glass touch sensing is ready for products that require a complete flat surface. It also can drive
the touch panel to get two fingers touch function that based on the Windows 7 support.
Figure 5.1: Bird
’s Eye View of Control Board
5.2 Windows 2000/XP/2003/Vista Universal Driver Installation
Before installing the Windows 2000/XP driver software, you must have the Windows 2000/XP system
installed and running on your computer.
5.2.1 Installing Software (projective capacitive)
If you have an older version of the driver installed in your system, please remove it first. Follow the
steps below to install the driver. Please make sure your USB controller device had plugged in advance.
When the system first detects the controller board, a screen appears that shows
“Unknown Device”.
Do not use this hardware wizard. Press Cancel.
Summary of Contents for APC-3x93P Series
Page 12: ...APC 3x93P User Manual 12 units mm Figure 2 1 Mainboard Dimensions ...
Page 50: ...APC 3x93P User Manual 50 Step 3 Read license agreement Click Yes Step 4 Click Next ...
Page 68: ...APC 3x93P User Manual 68 Hardware Saturn Hardware Configuration ...
Page 69: ...APC 3x93P User Manual 69 About To display information about eGalaxTouch and its version ...
