APC-3x93P User Manual
80
Multiple Monitors
Multiple Monitors support from two to six touch screen displays for one system.
The PenMount drivers for Windows 2000/XP support Multiple Monitors. This function supports
from two to six touch screen displays for one system. Each monitor requires its own PenMount
touch screen control board, either installed inside the display or in a central unit. The PenMount
control boards must be connected to the computer COM ports via the RS-232 interface. Driver
installation procedures are the same as for a single monitor. Multiple Monitors support the
following modes:
Windows Extends Monitor Function
Matrox DualHead Multi-Screen Function
nVidia nView Function
NOTE:
The Multiple Monitor function is for use with multiple displays only. Do not use this
function if you have only one touch screen display. Please note once you turn on this
function the rotating function is disabled.
Enable the multiple display function as follows:
1.
Check the
Enable Multiple Monitor Support
box;
then click
Map Touch Screens
to
assign touch controllers to displays.
Summary of Contents for APC-3x93P Series
Page 12: ...APC 3x93P User Manual 12 units mm Figure 2 1 Mainboard Dimensions ...
Page 50: ...APC 3x93P User Manual 50 Step 3 Read license agreement Click Yes Step 4 Click Next ...
Page 68: ...APC 3x93P User Manual 68 Hardware Saturn Hardware Configuration ...
Page 69: ...APC 3x93P User Manual 69 About To display information about eGalaxTouch and its version ...
