APLIC 303303/20190717TW012, User Manual

12

English

There are two different inlays which can be changed depending on the rod dia-

meter. The “S” inlay is suitable for slightly narrower bicycle frame bars and the “L” 

inlay for slightly wider ones.

5. Starting up

To operate the LED light set, charge the built-in batteries at first. Connect a 

suitable 5V DC charger such as your smartphone‘s charger with the supplied USB 

cable and connect it to the charger socket of the front or rear light. To be able to 

contact the microUSB connector of the rear light, please remove the rubber inlay 

of the rubber adapter first. Now fully charge both devices. To switch on the lights 

or change the lighting modes, press the on/off button.

6. Safety instructions and liability disclaimer

This product has a StVO approval (German road traffic registration ordinance) and 

is therefore permitted for use in traffic! Never try to open the device to carry out 

repairs or conversions. Avoid contact with mains voltages. Do not short-circuit 

the product. The device is not certified for use in the open air; only use it in dry 

conditions. Protect it from high humidity, water and snow. Keep it away from high 

temperatures. Do not subject the device to sudden changes in temperature or 

heavy vibration as this might damage electronic components. Examine the device 

for damage before using it. The unit should not be used if it has received an im-

pact or has been damaged in any other way. Please observe national regulations 

and restrictions. Do not use the device for purposes other than those described 

in the instructions. This product is not a toy. Keep it out of the reach of children