10
•
For replacing the internal battery see document
K530003 A11 battery replacement guide
available on
Aplicom Extranet. DO NOT USE OTHER BATTERIES THAN APLICOM DELIVERED. RISK OF
EXPLOSION.
•
DISCONNECT ALL CABLES FROM A11 connectors before changing internal battery.
•
Disconnect internal battery by removing the microSIM card if the unit is to be transported by airplane
and before long time storage.
INSTALLATION CHECKLIST
Action / Functionality
OK
Device installation
The place of installation is safe from accidental knocks and excessive humidity.
Device is fastened tightly and safely, with no possible interference with vehicle safety
system like Airbag. etc.
Cables
Cables are led carefully along a well-protected route to the device and the peripherals.
All cables are correctly connected and secured with fuses.
Cables are fastened or supported in such a way that during use they exert no torsion
on the connectors.
Antennas
The GPS antenna is fitted in such a way that its visibility to GPS/GLONASS satellites is
best possible and GSM/GPRS antenna has visibility to GSM/GPRS network.
Unit is installed as far away as possible from vehicle radio and its antennas and
wirings.
Make sure that the GPRS sending of the unit does not cause disturbances to car radio
or other vehicle systems.
External antenna cables are led carefully along a well-protected route to the device.
Check that vehicle windows do not have heating system that may block the
GPS/GLONASS signals for example in dashboard or windshield installations.
Check the antenna right orientation towards the GPS/GLONASS satellites and correct
fixing place and surface.
Power on device
Connect PWR and if IGN is used, turn it on.
If movement wake up is used, cause movement to start up the unit.
Final check
Before completing the installation work, rigorous checking of any disturbances
to vehicle or machine, where the unit is installed, must be made. Special
attention is needed to check the vehicle safety systems and radio and
multimedia equipment functions. This is to avoid recalls to service because of
un-noticed problems.
TROUBLE SHOOTING
Problem
Solution
No power
Check that all the cables and fuses are connected.
PWR is connected and IGN is on (if used).
No GPRS connection Check that SIM card is inserted.
Check PIN CODE requirements.
Check antenna.
Note: The disconnecting of external power cable does not reset the A11 unit.
No GPS position
Check that the GPS/GLONASS antenna has open sky view.
Check interferences from other structures to external GPS antenna if used.
NOTE! Electronic heated or UV-protected windshield may disturb GPS antenna sky view.
If none of the above helps, please contact your equipment dealer for further
assistance
.
