5
Select the installation method from these following options:
Figure 5. With the dual lock fastener. Before
installation, cut the dual lock fastener in two
pieces, 6cm each. Attach another half of the
fastener to the bottom of A11 device and other
half firmly to the surface on which the unit shall be
fixed. Use the fastener which is delivered in the
package.
Figure 6. There are four mounting lugs on the
sides of the A11 device cover. Install the A11
device using these mounting lugs with the cable
tie. Put the cable tie through the openings.
Maximum width of the cable tie is 4,8mm. Use
good quality cable ties, for example UV-Resistant
if sun is an issue.
Figure 7. With the screws. There are two holes for
max. 4mm screws.
