8
or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Part §15.105(b) Class B device:
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
For Canada ICES/RSS:
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of
the device.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
For Canada ICES/RSS:
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes:
1) L’appareil ne doit pas produire de brouillage;
2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Tout changement ou toute modification effectués par l’utilisateur et dont la conformité n’est pas
expressément approvéepar l’organisme responsable de sa conformité peut entraîner l’annulation de droit de
cet u
tilisateur de se servir de l’équipment.
IC Radiation Exposure Statement:
This EUT is compliance with SAR for general population/uncontrolled exposure limits in IC RSS-102 and had
been tested in accordance with the measurement methods and procedures specified in IEEE 1528.
REMARQUE IMPORTANTE
Déclaration IC d'exposition aux radiations Ce EUT est conforme avec SAR pour la population générale /
limites d'exposition non contrôlée à IC RSS-102 et a été testé en conformité avec les méthodes de mesure
et procédures spécifiées dans la norme IEEE 1528
