background image

Federal Communications Commission (FCC) Statement

15.105(b)

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

4. Please use the approved Micro-USB charging cable to charge the device (Note: some PCs cannot charge the device in
sleep mode), the battery capacity display will light, indicating the capacity of the battery has been charged. When the
battery capacity LED lights up, it means that the unit has been fully charged. After charging is complete, remove the
charging cable from the unit.

5.The maximum output current of this product is 2A, wireless charging and USB output can be used at the same time.

14. If find that there is a hidden danger, or other problems, you should immediately terminate the use.

9. Please do not short circuit the power supply.
10. Do not use the power supply near a fire or stove or at a temperature above 45 °C. Because the high temperature will
melt the plastic shell.

11. If the power is placed in the water, the safety protection parameters and indicators of the power supply may be
damaged, so that the power supply cannot be used normally. As a result, overheating, fire and explosion can occur with the
power supply.
12. It cannot use a heavy object or his object to squeeze the power supply to deform it.

13. If use a non-standard charger, or modify the specified charger parameters, the battery will overheat, burn and explode.

7. Please keep the battery dry and ventilated.

8. The power pack contains organic combustion products. If the power supply is not used properly, cracking, liquid
leakage, overheating, etc. may occur, and the battery may be permanently damaged. The power supply has built-in safety
protection.

6.The power pack has no side charging and discharge function, and cannot be discharged while charging.

Summary of Contents for AINW-P






Reviews: