User Guide and Instruction Manual
30
GPS
PATH: Devices menu > GPS
Select the box beside
Port
and select from Internal, RS232 (1~2), RS485 and LAN (1 ~ 16). If the RS232 or RS485
ports are in use for another function, they cannot be configured for GPS.
If RS232, RS485 and LAN ports are selected, select
Setup
…
and select the correct Baud Rate, Parity, Data Bits and
Stop Bits for the connected device.
If internal is selected, install GPS antenna onto the GPS connector on the rear of the recorder.
Selecting
Enable Recording
toggles On and Off. When set to On, the Recorder will record the GPS information.
Selecting
Use GPS Time Sync
toggles On and Off. When set to On, the Recorder will synchronize the time to the
GPS satellite every hour.
If the Internal GPS is selected, GPS data can be transmitted from the recorder to another device by using the
Bypass
function.
Select the port for transmitting the GPS data.
Select the box beside
Check GPS - Interval
to define GPS loss detection time. The Recorder will log and notify
GPS loss if the GPS receiver does not receive any GPS data during the set interval.
Summary of Contents for RoadRunner HD
Page 1: ......
Page 2: ......
Page 6: ...User Guide and Instruction Manual iv...
