8
Understanding the Bathing Process
Apollo Serenity™ Whirlpool tub is meant to be a relaxing,
pleasurable experience. By following these steps, you will receive the
most possible enjoyment out of the bathing process.
The Bathing Process
1.
With the door open, sit on the built-in seat, then pivot your body
until you are completely inside the tub.
2.
Ensure that your body is clear of the door closure area, then push
the door
Close
button.
3.
Turn on the water and adjust it to a comfortable water
temperature.
4.
Close the drain by turning the drain control know
counter clock-
wise.
You may open the drain by turning the knob clockwise.
5.
When the water level in the tub is above the highest whirlpool jet,
the whirlpool motor may be operated.
Caution: The Whirlpool pump can be damaged if it is run with-
out water.
The whirlpool jets are
multi-directional
and the pressure may be turned
up or down by turning the jet nozzle to the desired pressure.
The Showering Process
1.
Use the shower selector to select the hand held shower wand or
flexible shower head.
2.
Turn the water on and adjust the temperature.
3. Pull out the shower control button (on the faucet) to produce flow
through the shower.
Be sure to point hand-held wand into the tub.
4. When you have finished showering, simply turn off the water
supply valve.
In case of emergency, pull the
emergency stop button
. This will cut
the power to the door, allowing it to be manually pushed down to the
open position
.
Summary of Contents for SERENITY Whirlpool
