Apollo XPander XPA-IN-14011-APO, Commissioning Manual

5

© Apollo Fire Detectors Limited 2015

Quick Start Guide for XPander Diversity Loop Interface 

1. Select the  interface number 
or ID (range 1-5).

2. Select channels following 

Appendix B and checklist on 
the inside of the unit.

3. Set the address for the 
system.

4. Log on devices to the 
interface (for each interface).

For detailed instructions see page 07

For detailed instructions see page 13

For detailed instructions see 
Installation Guide 39214-926

For detailed instructions see page 08

Quick Start Guide for

XPander Diversity Site Survey

1. Use the site survey tool to 

check the signal strength.

2. Record all the survey signal 
strengths on the site survey 
sheet.

3. Fit the interfaces - as per 
instructions in the quick start 
guide below.

4. Log the devices on to the 
interface - as per instructions in 
the quick start guide below.

5. Check the signal strength 
for each logged on device and 
record on the site survey sheet. 

For detailed instructions see page 16

For site survey sheet see page 17

See Quick Start Guide for XPander 

Diversity Loop Interface below

For detailed instructions see page 08

For site survey sheet see page 17