Using the APP Recorder
6-22
8.
Auto Send Fault Summary
, do you want the Auto Send Fault Summary function to limit what is
sent to the Master Station to any faults less than 1 day old?
If
yes
, then click the
Don’t Auto Send Fault Summary if older than 1 day
check box.
If
no
, skip to the next step
This function works only if Auto Send Fault Summary is also checked.
9.
From the menu bar, click
Save
. At this point, you have completed configuring e-mail settings. It is
a good idea to send a test e-mail to ensure that messages will be sent properly. To do this,
complete the procedure,
To Test the Email Function
.
To Test the Email Function
1.
In the
Send Email
window, click the
Message
tab.
The
Message
tab appears, as shown in the following figure. From here, you can type an email and
manually send it to everyone in the
Recipient
list.
Figure 32: Manual Emailing Window
Summary of Contents for APP-601
