10
V. INSTALLING THE BRASS TRIM
1. STANDARD BRASS
(A) Spring Damper Handle - screw the handle onto the
damper rod counter-clockwise.
B) Draft Knob - screw directly into the hole in the draft
slide rod.
C) Brass Door Trim - factory installed.
2. OPTIONAL BRASS (BRASS FOR TRIM PANELS)
1. Mount the top and side strips to the trim panels with
the self tapping screws that are provided. Leave
approximately 1” at the top edges of the trim to be
covered by corner brass. If necessary, strips can be
easily cut with a hacksaw.
2. Mount the two brass corners, overlapping the top
and the side brass strips.
3. Remove the protective coating from the brass strips
before use.
FIGURE 10
FIGURE 11
Summary of Contents for 36-BW
Page 18: ......