Appalachian Stove & Fabricators 36-BW, Installation And Operation Procedures

9

6. INSTALLATION INTO FACTORY-BUILT 
CHIMNEY
NOTE: Use of aluminum type 13 gas vent for solid 
fuel is unsafe and prohibited by the National Fire 
Protection Association Code.

After the stove is positioned, suspend a plumb bob 
over the center of the damper opening to determine 
the chimney penetration point.

The Model 36-BW stove must be connected ONLY to 
a UL listed class A all fuel burning heating appliance 
chimney. CAUTION: SOME CHIMNEYS ARE 
AVAILABLE WITH A UL LISTING THAT ARE NOT 
CLASS A AND ARE NOT SAFE FOR USE WITH A 
SOLID FUEL APPLIANCE.

Install the chimney following the manufacturer’s 
instructions exactly. DO NOT DEVIATE FROM 
THESE INSTRUCTIONS!

The chimney should extend a minimum of 3 feet from 
the roof structure or 2 feet higher than the highest 
point within 10, whichever is greater. This assures 
proper chimney function and reduces the possibility of 
back drafts.

NOTE: All installations must meet local building and 
fire codes. Check with local building officials for 
assistance in getting permits, inspections and good 
advice.

7. IMPORTANCE OF PROPER DRAFT
Draft is the force that moves air from the appliance up 
through the chimney. The amount of draft in your 
chimney depends on the length of the chimney, local 
geography, nearby obstructions, and other factors. Too 
much draft may lead to excessive temperatures in the 
appliance and may damage the catalytic combustors. 
Inadequate draft may cause backpuffing into the room 
and “plugging” of the chimney catalyst.

NOTE: An uncontrollable burn or a glowing red stove 
part or chimney connector indicates excessive draft.

FIGURE 9 

INSTALLATION INTO FACTORY-BUILT CHIMNEY