600840-000037 Stratus ESG Installation Instructions (Experimental)
Rev. 1.2
Last Revised: May 9, 2016
Page 30 of 52
Figure 3: Ambient light sensor location
4.
Shine a light on the ambient light sensor. Verify that the signal percentage
increases.
5.
If you are using the 14V or 28V lighting bus: Adjust the lighting bus input to
minimum. Verify that the displayed value is 0%.
6.
If you are using the 14V or 28V lighting bus: Adjust the lighting bus input to
maximum. Verify that the displayed value is 100%.
5.4.
GPS
1.
Turn off all avionics except Stratus ESG.
2.
Enter into configuration mode on Stratus ESG.
3.
Press
FUNC
to advance to the GPS receive diagnostic screen and wait for the
NIC value to stabilize at or above zero.
4.
Turn on one avionic at a time. Verify that the NIC value does not drop below 7.
5.5.
Altitude
1.
Enter into configuration mode on Stratus ESG.
2.
Press
FUNC
or the arrow keys to advance to the altitude diagnostic screen.
3.
Verify that the altitude displayed is correct to your geographic location.
6. Using Stratus ESG
See the Stratus ESG Pilot’s Guide (600890-000049) for a full description of Stratus ESG’s
function.
Figure 4: Stratus ESG front panel