600840-000037 Stratus ESG Installation Instructions (Experimental)
Rev. 1.2
Last Revised: May 9, 2016
Page 42 of 52
ESG Interconnect
(Serial Altitude Encoder)
STRATUS ESG
AI RCRAFT POWER 1
AI RCRAFT POWER 2
AI RCRAFT GROUND 1
AI RCRAFT GROUND 2
28V LIGHTING BUS HI
14V LIGHTIN BUS HI
EXTERNAL STANDBY
EXTERNAL SUPPRESS IN
EXTERNAL SUPPRESS I/0
RS232-RX ALTITUDE
RS232-TX ALTITUDE
EXTERNAL I DENT
EXTERNAL SQUAT SWITCH
P1002 – XPNDR ANTENNA
P1003 – GPS ANTENNA IN
AUX PASS-THRU
2
21
1
20
15
33
7
14
32
5
24
25
26
11-33 VDC AI RCRAFT POWER
P1001
5A
MUTUAL SUPPRESSION (ARINC 709)
DME
TRANSPO NDER 2
XPNDR
ANTENNA
GPS ANTENNA
ALTITUDE
ENCODER
OUT
6
RF
(BNC)
RF
(TNC)
RF
TO LIGHT DIMMI NG BUS
3
10
11
7
IDENT INPUT
Optional
WoW
NOTES:
SO ME DETAIL IS REMOVED FO R CLARITY
1 UNLESS OTHERWISE SPECIFIED, ALL WIRING TO BE DO NE WITH 22 AWG WIRING
2 FROM SPLICE TO UNI T, WIRE LENGTH SHOULD NOT EXCEED 6 INCHES
3 TO CONTROL BRIGHTNESS WI TH THE AMBIENT LIGHT SENSOR, DO NOT CONNECT THESE PI NS AND SELECT
THE AMBIENT LI GHT SENSOR DURING BACKLIGHT SO URCE CO NFIG URATI ON
4 CONNECT ONLY 1 INPUT TO LIGHTING BUS
5 MUTUAL SUPPRESSION OUTPUT INTENDED FOR ARINC 709 BUS
6 ONLY ONE SUPPRESSIO N SOURCE MAY BE CONNECTED AT ONE TIME (OPTI ONAL)
7 OPTI ONAL INSTALLATI ON. TYPICALLY CONNECTED TO WEI GHT ON WHEELS SWITCH. REFER TO AIRCRAFT
MANUAL TO DETERMINE APPLICABI LITY.
8 DRAWI NG DEPI CTS INSTALLATI ON WI TH A SERIAL ENCODER. SEE PREVIOUS SHEET FOR PARALLEL
ENCODER WIRING
9 PI N 24 (RS232 TX ALTITUDE) CAN BE USED AS A SERI AL ALTITUDE SOURCE FOR OTHER EQUIPMENT
10 USING RG400, THE MAXIMUM CABLE LENGTH IS 14 FEET WITH A MAXIMUM OF 2 dB LO SS. IF THE
INSTALLATION REQUIRES MORE LENGTH, SELECT O THER 50 OHM COAX THAT WI LL PROVI DE A MAXIMUM 2 dB
LO SS.
11 ALL WIRING SHOULD HAVE A MINIMUM OF 3 dB LO SS AND A MAXIMUM OF 7 dB LO SS. EACH BNC OR TNC
CONNECTION IS ESTI MATED TO HAVE A 0.2 dB LO SS
2
2