ALM TYPE:
This option allows users to set a type of alarm input corresponding to the sensor signal in use.
NO:
Normally Open. This is to be used with the type of alarm sensor whose contact remains
open in normal conditions and closes in case of activation.
NC:
Normally Closed. This is to be used with the type of alarm sensor whose contact remains
closed in normal conditions and opens in case of activation.
ALM DURATION:
This option allows users to set alarms for a certain duration. You can select one of the six following
options:
0 SEC, 30SEC, 1 MIN, 5 MIN, 10 MIN,
and
NON-STOP.
D uration
Set ting
Alar m
activ ated
Alar m
deactivated
R eset
Alar m r ecor ding
N on-Stop
Alar m
activ ated
Alar m
deactivated
D uration
Alar m r ecor ding
D uration
NOTE: Recording may be interrupted at the time of Alarm-in or Alarm-out.
LIVE images may be interrupted at the time of Alarm-out.
PRE- ALARM:
This option determines that images prior to an alarm occurs will be recorded in the hard-disk drive.
When an alarm is triggered the device will record the image prior to the alarm for 5 seconds. (
10
frames/sec
)
ON:
Enables this function.
OFF:
Disables this function.
NOTE: If the device is already under recording mode before alarm occur, the pre-alarm
recording would not take effect.
MOTION SETTING:
The motion detection function is convenient for the people without alarm trigger input, but also can
used with alarm trigger input at the same time. If this function is enabled, the object movement would
trigger the alarm recording just like the outside trigger signal. Before using the motion detection
function, please turn the
CH1/ CH2/ CH3/ CH4
options as
ON
, and set the
SENTIVITY
(1 ~ 5 ) to a
suitable value.
34
Summary of Contents for DVR-3014ST
Page 2: ......
