CAUTION! The Top Tether (Apramo
®
Dual Tether™) is
secured ONLY when the indicator is completely green.
Hook the snap hook (18) onto the Top Tether anchorage
point recommended in your vehicle owner's guide. Look
for this sign in your vehicle or check with your vehi-
cle dealer.
Tighten the free end of Top Tether adjuster A (46) until the
Top Tether adjuster B (47) sat on top of the backrest of
vehicle seat.
Ensure the child car seat is at the desired recline posi-
tion, and then tighten the free end of Top Tether adjuster
B (47) until the indicator shows green.
13
14
15
4)
5)
6)
Press down on the central adjuster (04) and pull the
shoulder belts (05) towards you, (DO NOT pull on the
shoulder pads (06)) release the 5-point harness as far as
it will go.
Pull upwards on the adjusting ring (07), whilst pulling up or
pushing down the headrest (08) to the required position.
Adjusting the height of the headrest (08) will allow for the
shoulder belts (05) to be the same level as the child’ s
shoulders.
CAUTION! The shoulder belts (05) must not run behind the
back of the child, at ear height, or above the ears.
16
17 18
1)
2)
1)
2.3 Adjust harness and headrest
2.3.1 Adjust harness and headrest in the 5-point harness
installation (Group 0+/I)
Make sure the 5-point harness is removed.
(Refer to
section 5)
2.3.2 Adjust headrest (Group II/III)
18
13
47
46
48
14
15
08
05
18
07
08
17
06
05
19
04
16
47
48
11
2.2.2 Group I, Forward Facing
Make sure the child car seat is installed with ISOFIX and
forward facing.
Press the release button of the Top Tether adjuster B (47)
to release the Top Tether strap (48) to the desired length.
Hold the Top Tether adjuster A (46) horizontally, and use
the other hand pull the strap with the snap hook (18), to
the maximum or desired length.
Hook the snap hook (18) onto the Top Tether anchorage
point recommended in your vehicle owner's guide. Look
for this sign in your vehicle or consult with your vehi-
cle dealer.
Tighten the free end of Top Tether adjuster A (46) until the
Top Tether adjuster B (47) sat on top of the backrest of
vehicle seat.
Ensure the child car seat is at the desired recline posi-
tion, and then tighten the free end of Top Tether adjuster
B (47) until the indicator shows green.
11
12
13
14
15
1)
2)
1)
2)
3)
7)
8)
3)
4)
5)
6)
Make sure the child car seat is installed with ISOFIX and
forward facing.
Press the release button of the Top Tether adjuster B (47)
to release the Top Tether strap (48) to the desired length.
Hold the Top Tether adjuster A (46) horizontally, and use
the other hand pull the strap with the snap hook (18), to
the maximum or desired length.
11
12
2.2.3 Group II/III, Forward Facing
46
18
12
18
13
47
46
48
14
15
Tighten the free end of Top Tether adjuster A (46) until the
Top Tether adjuster B (47) sat on top of the backrest of
vehicle seat.
Tighten the free end of Top Tether adjuster B (47) until the
indicator shows green.
09
10
10
09
47
46
48
GB
10
GB
02
GB
11
Summary of Contents for ALL STAGE Series
Page 44: ......
