Fill spray gun bottle with
Aprehend
®
and set the spray
gun to the desired angle for
baseboard or ceiling application.
When extension wand is not
needed, the retention strap can
be removed from the trigger and
the spray gun used normally.
Pull the flat part of the retention
strap up and over the trigger to
keep the trigger fully depressed.
Angle
Adjustment
Knob
Baseboard Application
Ceiling Application
Insert both
loops of the
retention strap
over the spray
gun handle.
Use the battery or compressor
on/off switch to start and finish
the spray application.
1
Connect the extension wand
to the spray gun as pictured
above by following illustrated
directions to the right.
2
3
Bring the retention strap down
to the air hose nut.
4
5
Extension Wand Assembly and Use
A
B
C
D
A
spray gun
B
insert bracket
C
insert 7/16 ID washer onto
the threaded spray gun air
inlet (1/2 OD)
D
firmly attach the air hose
using the wrench
E
turn on the compressor
and check for auto stop
