A
B
C
D
Ф 6 drill bit
12-15mm
from bath
edge
4X45
Step 1: Position the wall profile (1) onto the bath , approximately 12-15mm from the outside bath edge to ensure that
the screen runs along the inside edge of the bath rim. (A).
Step 2: Level the profile with a spirit level , then mark the position using a pencil. Mark through the 3 pre-drilled screw
holes in the wall profile then drill the marked points using a 6mm masonry drill bit ,once this is done insert 3 wall plugs
(11) into the wall holes (B).
NOTE :You may find it easier to mark and drill the wall if you apply masking tape to it first.
Step 3: Secure the wall profile using 3 x ST4X45 screws (12). (C)
Step 5 : Carefully position the screen into the wall profile. (D)
Step 6 : Secure to the wall profile using 3 x ST3.5X10 screws (13) and cover caps (14,15) (E,F)
E
Ф2.75 drill bit
