Step 2.
2.1
Remove the wall profiles and drill the marked points using a 8mm masonry drill bit, once this is done insert 6 × wall
plugs (
No.12
).
2.2
Fix the wall profile (Seal profile side) to wall using the screws ST3.9 × 30 (
No.14
).
Step 1.3
Step 2.1
Step 1.1 & 1.2
Step 2.2
Step 1.
1.1
Position the wall profiles (
No.1
) to wall as shown (roughly 10mm from the front of the tray).
1.2
Level the frame using a spirit level.
1.3
Once you are happy that the frame sits on the tray correctly mark the wall through the 3 pre-drilled screw holes in the
wall profiles.
NOTE:
You may find it easier to mark and drill the wall if you apply masking tape to it first.
10mm
10mm
