ENGINE
RSV mille
3
- 86
◆
Oil the shift cam (8) and insert it in the relevant slot in
the casing.
◆
Attach the 3 gearshift forks inside the respective guides
of the shift cam (8).
◆
Insert the two gearshift rods (9), pushing them all the
way into the respective slots in the flywheel side half of
the engine casing.
3.7.2 ASSEMBLING THE DRIVING SHAFT
AND COUNTERSHAFT
Carefully read 0.2.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
◆
Apply a coat of MOLYKOTE
®
G-N on the housings of
the bushes for the driving shaft and countershaft.
◆
Insert the driving shaft (10) in the housing in the fly-
wheel side half of the engine casing.
NOTE
Position the lower connecting rod (11) towards
cylinder “2” (rear) and the upper connecting rod (12) to-
wards cylinder “1” (front).
a
CAUTION
Do not tilt the driving shaft during insertion so as to
avoid damaging the main bushes inside the housing.
◆
Insert the countershaft (13) in the relevant housing.
a
CAUTION
Do not tilt the countershaft during insertion so as to
avoid damaging the bearing bushes inside the hous-
ing.
M = MOLYKOTE
®
G-N.
E = LOCTITE
®
Anti Seize.
Summary of Contents for 8140172
