GENERAL TECHNICAL INFORMATION
2 - 30
PEGASO 650
Service intervals
The S
ERVICE
icon coming on to indicate that the vehicle is
due for first service coupon occurs when odometer reaches
1000 km. The next service intervals are indicated when
odometer will reach a multiple of 10000 km.
The service warning can be reset from 300 Km before the
scheduled interval and in this condition the service icon
should flash for 5 seconds and then go off.
Direction indicators
The instrument panel works as a control driver for direction
indicators, as single channel control and as synchronised
control for both channels ("Hazard"). Required features are
the following:
The hazard control device is a push-button.
Flashing frequency in normal operation: as per FMVSS 108
standard (60
÷
120 blinks/min.) and anyway
≈
87 blinks/min.
The instrument panel should be able to directly pilot a lamp
load up to 4x21W. Consider in any case the chance of
piloting even sundry loads (such as front lamps and rear
LEDs) or LEDs only for all 4 outputs. It is then necessary to
have 4 separate control channels. Minimum current per
channel will be 1mA.
Failure signal (burnt-out or short-circuited bulb) by doubling
the light flashing frequency (
≈
175 blinks/min.).
Protection against short-circuit (with indefinite short-circuit
stay time) for all outputs.
Hazard operation logic: can be enabled/disabled with key ON
only. After activation, it stays active even when taking the
key to OFF.
For the USA version, the instrument panel should be marked
DOT (SAE J590b standard, October 1965).
Hazard
The hazard control device is a push-button. It can be
enabled or disabled only with
KEY
-
ON
. When activated, the
direction indicators stay active even when removing the key.
To disable them, turn the key back to
ON
.
Summary of Contents for Pegaso 650 2005
