APRILIA RST mille FUTURA Manual Download

Page: 76 / 160

use and maintenance

RST mille Futura

place. Slipping the clutch to keep the
vehicle in one place on an uphill grade
will very quickly ruin the clutch and
overheat the engine.

Before entering a turn, slow down, us-
ing the brakes and the engine, to a con-
stant speed and then accelerate slightly
through the turn. Avoid braking at the
last moment. This can cause you to lose
control of your vehicle.

If the brakes are operated continuously
on downhill grades, the discs and pads
will overheat, reducing the braking effi-
ciency. Use engine compression and
downshift to retard your vehicle while
going downhill. Use the brakes as little
as possible to maintain a safe speed.

Never coast downhill with the engine off
and/or the clutch disengaged or the
transmission in neutral.

On roads that are wet or covered with
snow, ice or mud, ride very slowly,
avoiding braking or accelerating or ma-
neuvering quickly. Hold the handlebars
firmly.

Failure to heed these warnings can
cause an upset with subsequent seri-
ous injury or death.

WARNING

Pay very close  attention to  any obsta-
cles or variations  of  the  road surface.
Uneven  roads,  rails,  manhole  covers,
painted traffic stripes, traffic dots all be-
come slippery when wet. Avoid particu-
larly steel plates which are sometimes
used  during  road  maintenance.  They
become  more  slippery  than  ice  once
they  are  wet  by  rain  or  other  water
source. If you must ride on such surfac-
es,  decrease  your  speed  and  operate
the  throttle,  brakes  and  steering  very
gently.

Always  use  the  turn  signals  any  time
you intend to  change lanes or change
direction,  and avoid  sudden or abrupt
turning.
Switch  off  the  direction  indicators  as
soon as you have changed direction.

Overtake and pass only with care, espe-
cially in rainy weather when a water
cloud created by larger vehicles reduces
visibility and the slip stream could cause
you to lose control of your vehicle.

25..).').

The internal parts of the engine and trans-
mission must be properly run-in to ensure
their long life and dependable operation.
If possible, while breaking in your vehicle,
ride on hilly roads and/or roads with many
curves  so  that  the  engine  and  transmis-
sion undergo lots of speed changes. It is
also important that, during the run-in peri-
od, the suspension and brakes be treated
gently to allow the mating parts to bed.
Th er ef or e,   avo id   h ar d  b ra kin g,   hig h
speeds  or  very  bumpy  roads  during  the
break in period.

NOTE

Only after the first 900 mi (1,500

km) of running-in you can expect the best
performance from the vehicle.

During break in, obey the following
rules:

◆

Do not open the throttle abruptly or fully
at low engine speed. This rule applies
even after break in has been completed.

◆

During the first 60 mi (100 km), apply the
brakes with caution, avoid sudden and
prolonged braking. This ensures correct
bedding in of the pads on the discs.

◆

During the first 600 mi (1,000 km), never
exceed 6,000 rpm.

WARNING

After the vehicle has been operated for
600 mi (1,000 km) perform the “checking
operations” shown in column “After run-
ning-in” of the REGULAR SERVICE IN-
TERVALS CHART, see p. 84. Rectify any