INSTALLING THE CLUTCH CONTROL PIN
BUSHING
•
Before carrying out the installation of
the bushing, it is necessary to warm up
the cover.
•
Position the guide (1) to insert the
bushing (2) as indicated in the figure.
•
Insert the bushing so that the process-
ing notch (3) is aligned with the notch
on the guide (4).
Specific tooling
020926Y
Tool for fitting clutch bushing
•
Then insert the tool to push the bushing
into the seat until it stops.
•
Position the starting transmission gear
on the crankcase.
•
Position the gasket and the two dowel
pins in the clutch cover.
•
Insert the clutch cover, making sure to
have correctly engaged the clutch con-
trol lever and the rack shaft.
•
Insert the five special screws (5) and
the eleven fastening screws (6) around
the perimeter, taking care to also insert
the relative washers.
•
Tighten the screws working in stages
and diagonally.
RSV4 1100 Factory
Engine
ENG - 255
Summary of Contents for RSV4 1100 Factory 2021
