Pump Housing
Cover
Solder wave nozzle
Emergency
Stop
Foot pedal
Board Holder
Plate
Board Holder
Height
Adjustment Knobs
Blow-thru
heated air
nozzle
(optional)
Laser Light
Locator
Foot pedal
connection
(not shown)
Leveling Feet
Fig. 2
5. When solder falls below recommended level, add solder until the proper
level is reached.
6. Replace top insulation, and board holder plate.
7. Turn machine ON at rear of unit: When machine is first turned on, display
will show RUN mode and program (00) will show factory set parameters.
Heating elements will begin melting solder to set temperature. (Refer to sec VI.)
G. Option: If equipped with heated blowoff option (model GW-10A), attach shop air
and blowoff nozzle assembly to rear of unit (refer to Fig.1)
-3-
