-3a-
INSTALLING OR CHANGING THE NOZZLE:
CAUTION: SOLDER IS HOT!
CAUTION: USE SAFETY PRECAUTIONS WHEN PERFORMING THIS OPERATION.
USE SAFETY GLASSES, FACE SHIELD, HIGH TEMPERATURE GLOVES, & APRON.
CAUTION : Nozzle must be completely dry of any moisture (from cleaning etc.) prior
to immersing in solder bath.
1. Using high temperature gloves, lift off Board Holder Plate to access solder.
2. IMPORTANT! Ensure nozzle is completely dry of any moisture! It is recommended
that nozzles recently washed may be preheated at temperatures up to 200° F (94° C)
in order to expedite the drying process.
3. Using pliers, place nozzle in molten solder for at least 2 minutes before installing on
high pressure chamber Bayonet -Mount.
4. Using pliers, install nozzle on Bayonet-Mount at pressure chamber.
5. Replace Board Holder Plate before using nozzle.
