-7-
E. Changing Programs:
To change to a different program, press [ F ], Prg/EDIT will be displayed, press [ ]
to change the program #, then press [ F ] to switch the machine into the RUN mode.
F. Editing Parameters:
1. Press [ F ], the screen will display the Prg #/EDIT. The machine is now in EDIT
mode.
2. Press [ ], the cursor will move to the solder temp. setting. Change the value
of the first digit by pressing [ ]. To shift to the next digit press [ ]. When satis-
fied, press [ ] to store the changes. The cursor shifts to next parameter. Make
changes by using the [ ] and [ ] keys. When satisfied with the entire menu,
press [ F ] to switch the machine to RUN mode.
G. Changing Manual/Auto Mode:
For convenience, it is sometimes desirable to switch the machine to manual mode.
For example, when you want to make trial runs for a certain board type or to do
some troubleshooting work.
Press [ F ]. Prg #/EDIT will be displayed. Change to Prg # 00. The machine is now
in the manual mode. You can now change the parameters and run the machine.
1 . When position switch is in I N S E RT position the wave will activate as long as
the foot pedal is pressed. (Refer to Fig. 4)
2 . When position switch is in R E M O V E position the optional blow through will
activate as long as the foot pedal is pressed. (Refer to Fig. 4)
When satisfied with parameters, select the (new) Prg # and press [ ] to go to
Auto Mode. The # selected will now be stored.
H. Turning Individual Parameters ON and OFF:
Go to Prg # 00 and press [ ], the cursor will be on the status line (lower line of the
display). Press [ ] to toggle the parameter ON or OFF. Press [ ] to go to next
parameter.
