3
online
aptsources.com
Sync Output Connector
-
Provides the capability to monitor a 5 VDC output signal.
Remote Output Connector
-
Provides output to monitor PASS, FAIL, TEST-IN-PROCESS via
relay contact closures.
Automated Interface Card
-
RS-232 interface card used to control, program, and capture data.
Linking Card (OPT 8)
-
Provides input and output communication ports for operating multiple
instruments in parallel and polyphase modes.
Interface Input:
Connector used to attach the instrument to a master power source.
Connecting the interface cable to this port automatically designates the instrument as a
slave unit.
Interface Output:
Connector used to attach the instrument to a slave power source.
Connecting the interface cable to this port automatically designates the instrument as a
master unit unless an interface cable is also connected to the Interface Input port (in this
case the instrument is automatically configured as a slave unit).
Input Terminal Power Block
-
Provides input power to the instrument.*
G
:
Earth ground (chassis) connection
N
:
Neutral input screw terminal
L
:
Line input screw terminal
Output Terminal Power Block
- P
rovides output power to the DUT.
Ns
:
Neutral sense screw terminal
N
:
Neutral output screw terminal
G
:
Earth ground (chassis) connection
L
:
Line output screw terminal
Ls
:
Line voltage sense screw terminal
BACK PANEL CONTROLS
1
4
1
2
3
4
5
4a
4b
5a
5c
5b
6a
6c
6b
6
6e
6d
2
3
4a
4b
5a 5b 5c
6a 6b 6c 6d 6e
5
6
Models 310XAC and 320XAC
*Models 310XAC and 320XAC require 1Ø 100-240 VAC ± 10%, 47-63 Hz.
