45
Power UP = indicates the power up mode that is programmed into the
instrument.
Power UP Mode: indicates the power up mode that can be programmed into the
instrument.
The power up modes available are ON, OFF or LAST. In the ON mode output
will be supplied on power up of the instrument. In the OFF mode output will NOT
be supplied on power up of the instrument. In the LAST mode output will be
supplied according to the last state the instrument was in prior to power off.
Press the Change soft key to toggle the Power UP Mode to ON/OFF/LAST. To
save the parameter, press the Enter soft key. To cancel the editing of the Power
Up feature press the Esc soft key. When the Enter soft key is pressed the
Power Up parameter is accepted and you transition into the next system
parameter.
4.3.7 Editing Loop Cycle (PROGRAM Mode only)
Use the
∧
,
∨
soft keys to navigate to the Loop Cycle parameter (only selectable
for AC output). Pressing the Edit soft key will provide the following screen:
Loop Cycle = indicates the number of loop cycles that will be performed when the
output is active.
Loop Cycle Range: = indicates the selections available for the Loop Cycle
Range.
Summary of Contents for 310XAC
Page 13: ...13 320XAC 340XAC...
Page 116: ...116 1 Test Complete OK WAI Wait for next command...