46
The options available are 0 – 9999, 0=Cont., 1=Off. The 0 – 9999 selection
programs the instrument to repeat the test cycle x number of times. The 0=Cont.
selection indicates that the test loop will repeat in . The 1=Off selection
indicates that the test loop will perform only one cycle. Use the numeric keypad
to enter in the Loop Cycle Range. Press the Enter soft key to accept the
parameter. To cancel the editing of Loop Cycle Range, press the Esc soft key.
To move to the next system parameter for editing, press the Next or Prev soft
key. The Exit soft key is also available to return to the System parameter screen.
When the Enter soft key is pressed the Loop Cycle Mode is accepted and you
transition into the next system parameter.
4.3.8 Editing V Hi-Lmt & V Lo-Lmt (MANUAL Mode only)
Use the
∧
,
∨
soft keys to navigate to the V Hi-Lmt or V Lo-Lmt parameter.
Pressing the Edit soft key will provide one of the following screens:
V Hi-Lmt = indicates the voltage high limit that is programmed into the
instrument.
Voltage High Limit Range: indicates the voltage range that can be programmed
into the instrument.
V L-Lmt = indicates the voltage low limit that is programmed into the instrument.
Voltage Low Limit Range: indicates the voltage range that can be programmed
into the instrument.
To change the voltage high limit or low limit use the numeric keypad and type the
Summary of Contents for 310XAC
Page 13: ...13 320XAC 340XAC...
Page 116: ...116 1 Test Complete OK WAI Wait for next command...