67
Controls
regarding current output based on voltage output range). Setting of
voltage range may not influence the existing output voltage setting.
To change the voltage, use the numeric keypad and type the voltage. Once you
type in a number a shaded black box ( ) will begin blinking acknowledging the
parameter is being changed. Press the Enter soft key to accept the parameter,
or press the Esc soft key to move back to the voltage parameter screen. When
the Enter soft key is pressed the voltage parameter is accepted and the system
transitions into the next parameter: Frequency.
To change the Voltage mode from Auto to High press the Change soft key to
toggle between the two selections. To accept the selection, press the Enter soft
key. To cancel the selection, press the Esc soft key. You must press the Enter
soft key to accept the range. To transition into the next parameter of frequency
output you must press the Next soft key if you do not change the voltage setting.
If you wish to bypass editing this parameter and move to the next parameter you
can press the Prev or Next soft key.
4.6.6 Editing Frequency
Use the
∧
,
∨
soft keys to navigate to the Frequency parameter (only selectable
for AC output). Pressing the Edit soft key will provide the following screen:
Frequency = indicates the frequency currently programmed into the instrument.
Frequency Range: 40.0 – 500 Hz indicates the frequency range that can be
programmed into the instrument.
To change the frequency, use the numeric keypad and type the frequency. Once
you type in a number a shaded black box ( ) will begin blinking acknowledging
the parameter is being changed. Press the Enter soft key to accept the
parameter, or press the Esc key to move back to the Frequency Parameter
screen. When the Enter soft key is pressed the frequency is accepted and you
transition into the next parameter: Transient.
If you wish to bypass editing this parameter and move to the next parameter you
Summary of Contents for 310XAC
Page 13: ...13 320XAC 340XAC...
Page 116: ...116 1 Test Complete OK WAI Wait for next command...