85
accepted and you transition into the next parameter: Memory Cycle.
If you wish to bypass editing this parameter and move to the next parameter you
can press the Prev or Next soft key.
When the connect mode is ON there will be an underscore _ next to the step
number in the set screen. It will look as follows:
4.6.27 Editing Phase Set (Option 08 – PROGRAM Mode only)
Use the
∧
,
∨
soft keys to navigate to the Phase Set parameter. Pressing the Edit
soft key will provide the following screen:
Phase Set = indicates the Phase Setting mode for operating two instruments in a
master-slave configuration.
Phase Setting Mode: indicates the Phase Setting mode that can be programmed
into the instrument.
The Phase Setting Modes available are L1-N and L2-N (two interconnected
instruments) or L1-N, L2-N and L3-N (three interconnected instruments). Press
the Change soft key to toggle the mode. To save the parameter, press the Enter
soft key. To cancel the editing of the Phase Setting Mode, press the Esc soft key.
When the Enter soft key is pressed the Phase Setting Mode is accepted and you
transition into the next system parameter: Function.
If you wish to bypass editing this parameter and move to the next parameter you
can press the Prev or Next soft key.
Summary of Contents for 310XAC
Page 13: ...13 320XAC 340XAC...
Page 116: ...116 1 Test Complete OK WAI Wait for next command...