98
If three (3) instruments are connected and set for Polyphase mode the Set
screen will appear as follows:
6.3
Initializing a Test in Parallel or Polyphase Mode
The front panel display(s) of the slave unit(s) will not be editable in Parallel or
Polyphase modes. All user editable controls will be available from the front panel
of the master instrument. After all parameters have been entered into the
instrument, the operator may begin the test.
While a test is running, the front panel display will include the Phase key.
Pressing the Phase key allows the operator to view the meters for each individual
phase, as well as total measurements.
For detailed information on initializing a test, please refer to section
5. Test
Modes
.
6.4
Error Messages in Parallel and Polyphase Mode
If the power to the master instrument is turned off during operation or the
interface cable is unplugged, the slave instrument display will show the following
message:
Summary of Contents for 310XAC
Page 13: ...13 320XAC 340XAC...
Page 116: ...116 1 Test Complete OK WAI Wait for next command...
