4
AU
Telephone Helpline: 1300225960
Operation
Plug in Vacuum Pack Machine. The machine is now ready for use.
1. Place the open end of the bag across the Sealing Bar.
2. Press the Handle down firmly. Indicator light will turn red. Keep then handle being pressed down.
3. When sealing is complete indicator light will turn off. Bag should now be sealed.
4. Remove bag and inspect bag and seal.
Note: A good seal will look clear upon inspection. If the seal is spotty,
incomplete, wrinkled, white or milky, adjust timer knob and reseal.
Cleaning, Care & Maintenance
• Always allow to cool before cleaning.
• Disconnect from Power Supply.
• WARNING: Do not allow any water to spill into the appliance when cleaning.
• Use warm, soapy water and a damp cloth to clean the appliance.
• Dry thoroughly after cleaning.
• An APURO dealer or qualified technician should carry out repairs if required.
Troubleshooting
Fault
Probable Cause
Solution
The appliance is
not working
The unit is not switched on
Check the unit is plugged in correctly and
switched on
Plug or lead is damaged
Call APURO agent or qualified Technician
Power supply
Check power supply
Bags are not
sealing correctly
Moisture in bag under the sealing
bar
Ensure inside of the bag is dry and free from
moisture where it is to be sealed
End of bag not placed above sealing
bar
Move end of bag over sealing bar
GJ459-A_A5_v2_20210831.indb 4
GJ459-A_A5_v2_20210831.indb 4
2021/8/31 15:40
2021/8/31 15:40
