38
Smart Security
PANDUAN
PENGGUNA
Motion Sensor
If the motion sensor beeps, and the LED indicator
flashes continuously, means the battery is low. Replace
immediately with a new battery.
No. The motion sensor included the Home Security Kit
is a standard motion sensor. If you have pets at home,
please adjust the sensor installation height so that your
pet can roam freely below the height of the sensor
detection area without causing an alarm to sound.
•
Please make sure the Aqila Securehub™ panel is in
Arm mode, not in stay Arm mode or Disarm mode.
•
Make sure the motion sensor LED lights up when
you walk in the detection area.
•
Movement must pass through the detection area
and within a range of 8 meters.
•
The sensor enters sleep mode to save power after
the first detection. If there is no movement within 4
minutes, the Sensor will return to working state. If
the detection appears within 4 minutes, the time the
Sensor returns to its working state will be increased
and adjusted.
•
Make sure the battery contacts inside are good.
•
Check if the electronic board is properly installed.
•
If the zone jumper changes, reconnect the sensor to
the system.
•
Check whether there are pets in the house. The
motion sensor is a normal standard unit, not Pet-
Immunity sensor.
•
Avoid installing motion sensors in places where
rapid heat changes occur such as windows, air
conditioners, lights, electric heaters, refrigerators,
ovens, stoves, and others.
•
Avoid direct sunlight.
•
The mounting height and range must be within the
detection area.
Why does the Motion Sensor
beep without detecting the
movement of people?
Can the motion sensor
differentiate between
humans and pets
(Pet-Immunity)?
There is no one passing in
the room, but the sensor
triggers an alarm.
Why doesn’t the motion
sensor detect motion?
