Installation Manual
::
Aqua 9+ Natural Ionic Calcium Water System
7
Copyright © Aqua 9+ Beverage
DRILLING FAUCET HOLE IN SINK
Stainless Steel Sinks & Porcelain Sinks:
1. Drilling through a stainless steel sinks can be achieved by marking a center punch & drilling
a 3/8” guide hole.
2.
Use a 7/16 or 1/2” carbide drill to enlarge the hole.
3. For porcelain sinks, mark the location of the hole. Use some masking tape to protect the
area where the hole is to be drilled on the sink surface. Use a 7/16 or 1/2” drill. Make sure
when starting a drill, to begin slowly through the porcelain portion of the sink so that chip-
ping is cut down to minimum.
MOUNTING THE FAUCET
1. Disassemble the bottom portion of the faucet
2. Place into hole of sink and reassemble faucet from underneath sink (see figure 5)
3. Tighten nut on faucet bottom while keeping faucet straight as desired on sink.
4.
Connect 1/4” tubing to bottom of the faucet shank using the insert, ferrule, and
compression nut.
STANDARD FAUCET
Faucet
Threaded Shank
Plastic Washer
(Optional Chrome
Plated Brass Washer)
Rubber Washer
Hole for Spray Hose
(or Drill. new 1/2
” Hole)
Locating Washer
Locking Washer
Brass Nut
Brass lnsert
Plastic Ferrule -(tape part should
point towards faucet shank)
Brass Compression Nut
Figure 5. Faucet Assembly
1/4
” Tubing
